Tile work that holds up
decade after decade.

A standard bathroom floor runs one to two days for setting, then another day for grouting after the mortar cures. A full shower surround with waterproofing membrane typically spans three to four days. Kitchen backsplashes are often done in a single day. These timelines assume the substrate is sound and no demolition is needed.

Not necessarily. We assess whether the existing surface is stable enough to tile over, which saves cost and debris disposal. In wet areas like showers, we almost always recommend removing old tile to inspect for moisture damage and apply a fresh waterproof membrane underneath.

Unsanded grout is used for joints under 1/8 inch wide. It is also the right choice for polished marble and glass tile where sanded grout would scratch the surface. Sanded grout contains fine aggregate for strength in wider joints, and it resists cracking better in high-traffic floor applications. We select the appropriate type based on your tile choice and joint width.

Yes, with the right preparation. Wood deflects under load, and tile does not flex. We typically install a layer of cement backer board or use a crack-isolation membrane over the plywood to decouple the tile from subfloor movement. In older Atlanta homes with thinner subfloor assemblies, we may also add a layer of 1/4-inch backer to bring the system up to spec.

We apply a penetrating sealer to porous grout joints as part of our standard finish process. This is done after the grout has cured fully, typically 48 to 72 hours after application. Sealing reduces staining and moisture absorption, which matters especially in kitchens and bathrooms.

We work regularly in Midtown Atlanta condos and mixed-use buildings. This includes coordinating freight elevator reservations, adhering to building noise ordinances, and using low-VOC adhesives where required by building management. We request building access requirements from you before the job begins so there are no delays.